How to Install a JNP10K-PWR-AC Power Supply
The JNP10K-PWR-AC power supply in an MX10016 chassis is a hot-insertable and hot-removable
field-replaceable unit (FRU). You can install up to 10 power supplies in an MX10016 router chassis. All AC
power supplies install in the rear of the chassis in the slots provided along the left side.
CAUTION: Do not mix AC and DC power supplies in the same chassis.
NOTE: See the heat symbol . Wear heat-resistant hand gloves while accessing the fan
tray and power supply.
Before you install an AC power supply in the router:
•
Ensure you understand how to prevent ESD damage. See “Prevention of Electrostatic Discharge Damage”
on page 303.
•
If the AC power source outlets have a power switch, set them to the off (O) position.
Ensure that you have the following parts and tools available to install an AC power supply:
•
Electrostatic discharge (ESD) grounding strap
•
A number 1 Phillips (+) screwdriver
•
Power cords appropriate for your geographical location. See “MX10016 Power Cord Specifications” on
page 104.
•
Power cord retainer clips
•
Replacement power supply or a cover panel for the power supply slot
To install an AC power supply in an MX10016:
175
To Next Page
Loading...
Need help?
General
