6. Unscrew the captive screw counterclockwise by using the number 1 Phillips (+) screwdriver (see
Figure 72 on page 174).
7. Rotate the captive screw away from the faceplate of the power supply to release the latch.
8. Taking care not to touch the power supply output connections, pins, leads, or solder connections, place
one hand under the power supply to support it. Grasp the power supply handle with your other hand,
and pull the power supply completely out of the chassis.
CAUTION: Do not strike the output connections of the power supply against any
object. If the connection hits a solid object, it could damage the power supply.
CAUTION: See the heat symbol . The power supply surfaces are hot. Allow
a few minutes for the power supply to cool by pulling the power supply halfway out
of the chassis, or wear protective, heat-resistant gloves while removing the power
supply.
9. If you are not replacing the power supply, install the cover panel over the slot.
Figure 72: Removing a JNP10K-PWR-AC Power Supply from an MX10016
g050732
Keep latch in open position during removal.
174
To Next Page
Loading...
