RELATED DOCUMENTATION
MX10016 Rack Requirements | 93
Clearance Requirements for Airflow and Hardware Maintenance for an MX10016 | 95
MX10016 Chassis Lifting Guidelines | 279
Unpacking an MX10016 Router and Components
IN THIS SECTION
Unpacking an MX10016 | 128
Unpacking Line Cards, Routing and Control Boards, and Switch Fabric Boards | 131
Comparing the MX10016 Order to the Packing List | 132
Unpacking an MX10016
After you prepare the installation site as described in “Site Preparation Checklist” on page 89, you can
unpack the router.
NOTE: The chassis is maximally protected inside the shipping box. Do not unpack it until you are
ready to begin the installation.
Ensure that you have the following parts and tools available to unpack the MX10016:
•
A 13/32 in. (10 mm) open-end wrench or socket wrench to remove the bracket bolts from the shipping
pallet
•
A box cutter or a packing knife to slice open the nylon straps and tape that seal the crate and boxes
The chassis ships in a cardboard box that has a two-layer wooden pallet base with foam cushioning between
the layers. The router chassis is bolted to the pallet base.
128
To Next Page
Loading...
Need help?
General
