Juniper MX10016 Hardware Guide

Removing and Installing MX10016 Power System
Components
IN THIS SECTION
How to Remove a JNP10K-PWR-AC Power Supply | 172
How to Install a JNP10K-PWR-AC Power Supply | 175
How to Remove a JNP10K-PWR-AC2 Power Supply | 179
How to Install a JNP10K-PWR-AC2 Power Supply | 183
How to Remove a JNP10K-PWR-DC Power Supply | 187
How to Install a JNP10K-PWR-DC Power Supply | 190
How to Remove a JNP10K-PWR-DC2 Power Supply | 197
How to Install a JNP10K-PWR-DC2 Power Supply | 200
How to Remove a JNP10K-PWR-AC Power Supply
The JNP10K-PWR-AC power supply in an MX10016 router is a hot-removable and hot-insertable
field-replaceable unit (FRU). You remove AC power supplies from the rear of the chassis.
CAUTION: Before you remove a power supply, ensure that you have power supplies
sufficient to power the router left in the chassis. See “Power Requirements for MX10016
Components” on page 97.
Before you remove an AC power supply from the chassis:
•
Ensure you understand how to prevent ESD damage. See “Prevention of Electrostatic Discharge Damage”
on page 303.
Ensure that you have the following parts and tools available to remove an AC power supply from an
MX10016 router:
•
Electrostatic discharge (ESD) grounding strap
•
Phillips (+) screwdriver, number 1
•
Replacement power supply or a cover panel for the power supply slot
172

Juniper MX10016 Specifications

General

Brand	Juniper
Model	MX10016
Category	Network Hardware
Language	English