NOTE: If the 1 or 2 and the OK LED are unlit, the power cables are not installed properly or the
power supply has failed.
If the 1 or LED is lit green and the OK LED is unlit, the power supply is not installed properly or
the power supply has an internal failure.
If the ! LED is blinking, add a power supply to balance the power demand and supply.
RELATED DOCUMENTATION
MX10016 Power Planning | 96
MX10016 Routing and Control Board
IN THIS SECTION
MX10016 Routing and Control Board Description | 75
MX10016 Routing and Control Board LEDs | 78
MX10016 Routing and Control Board Description
IN THIS SECTION
Routing and Control Board Functions | 76
Routing and Control Board Components | 76
The Routing and Control Board (RCB) is responsible for system management in an MX10016 router (see
Figure 33 on page 76). The chassis can run with one or two RCBs. The base configuration ships with one
75
To Next Page
Loading...
