3. Install Junos OS by choosing one of the following options:
•
If you have a snapshot saved on the emergency boot device, the system prompts you with the
following option.
Junos Snapshot Installer - (c) Juniper Networks 2013
Reboot
Install Junos Snapshot [14.1X53-D11_vjunos.61]
Boot to host shell [debug]
Select Install Junos Snapshot to install the snapshot.
•
If Junos OS is installed at the factory on the emergency boot device, the system prompts you with
the following option.
Juniper Linux Installer - (c) Juniper Networks 2014
Reboot
Install Juniper Linux Platform
Boot to host shell [debug]
Select Install Juniper Linux Platform to install the Junos OS software from the emergency boot
device.
The device copies the software from the emergency boot device, occasionally displaying status messages.
Copying the software can take up to 12 minutes.
4. After the software is copied from the emergency device to the device, the device reboots from the
internal flash storage on which the software was just installed. When the reboot is complete, the device
displays the Junos OS login prompt:
root@router#
5. Create a new configuration as you did when the device was shipped from the factory, or restore the
previously saved configuration file to the device.
6. Remove the emergency boot device.
SEE ALSO
Creating an Emergency Boot Device | 245
248
To Next Page
Loading...
Need help?
General
