KAMAZ 5490 - Page 112

6-9
№
Description of procedure
Technical requirements and instructions
3
Check visually the state of and
fastening of front spring brack-
ets.
Cracks in brackets and loose rivets are not tolerable.
4
Check the state and attachment
of wheel disks.
See subsection «Tire maintenance».
5
Check the fastening of brake
chambers.
Check the fastening ofbrake chambers.
The tightening torque for fastening brake chambers 180 - 220 N⋅m (18 to
22 kgf⋅m).
6
Inspect visually the state and
fastening of torque rod.
Inspect visually the state and fastening of upper torque rod brackets.
Vehicle driving is prohibited till fault correction.
Rear bracket
of front spring
Front bracket
of front spring
Securing of the
front axle brake chambers
Securing of the drive axle
brake chambers