KAMAZ 5490 - Page 168

7-37
Replacing the bulb of side repeater lights
1. Loosen the fastening screw, remove the diffus-
er (see figure Side repeater light).
2. Change the bulb.
3. Install the diffuser, tighten fastening screws.
Replacing the flashing light bulb
1. Unscrew fastening screws, remove the diffuser
(see Fig. Flashing light
lamp).
2. Change the bulb.
3. Install the diffuser, tighten fastening screws.
Replacing the searchlight bulb of the
hitch lighting
1. Loosen the fastening screw 1, remove the bulb
in upward direction (see Fig. Searchlight bulb of the
hitch lighting).
2. Take out the plug 4.
3. Disconnect the clamping spring 6, take out the
halogen lamp holding it by the socket 5.
4. Install the new halogen lamp so that the socket
plate matches the recess in a holder.
5. Secure the clamping spring, connect the plug
with bulb contact.
6. Install the lamp to its place, tighten the screw 1.
Flashing light lamp
1 - diffusor
1
Side repeater light
1
- fastening screw;
2
- diffusor
1
2
Searchlight bulb of the hitch lighting
1 - screw; 2 - diffusor; 3 - deflector; 4 - plug;
5 - halogen lamp socket; 6 - clamping spring
3
4
5
6
1
2