Keba KeDrive D3-DU 3 A Series User Manual

D3-DU 3xx/A, /B Operating behavior
Project engineering manual V1.09
85
© KEBA 2021
1. Level 2. Level 3. Level 4. Level Description
Select
Clone
<Dateiname
>
File selection
The following file names are valid,
where <n> is the index and <ip> is
the EoE IP address of the drive:
● DriveClone_<n>.tftp-
com
● Drive-
Clone_<n>[..].tftp-
com
● DriveClone_<ip>.tft-
pcom
Restore
Clone
Are you
sure?
Confirm execution
Restore
Clone
Restore
Clone...
Recovery is performed
The following states can be dis-
played:
● Restore Clone Ok: Suc-
cessfully completed.
● Restore Clone Failed:
An error has occurred.
Menu for simultaneous operation of several drives (Menu-Drives))
The following table describes the menu below Menu-Drives. With this menu
all found drives can be operated simultaneously.
1. Level 2. Level 3. Level 4. Level Description
Drives
Menu
Drives-1
Service
Drives-1
Service
Firmware
Update
Firmware
Update
<Location>
Performing a firmware update for all
drives
EoE must be enabled for this com-
mand.
Locations:
● local: on CFast card of the
control under root/appld-
isk/application/
drive/drive
● /media/usb<x>: on USB
stick (x: number of the USB
port of the control)
Firmware
Update
n.a.
No (valid) firmware file was found in
the directory.
Select
Firmware
<Filename>
Firmware file selection
The following file names are valid:
● DriveFirmware.tftp-
com
● D3_DA_FW_[..].tftp-
com

Keba KeDrive D3-DU 3 A Series Specifications

General

Brand	Keba
Model	KeDrive D3-DU 3 A Series
Category	Control Unit
Language	English