Keithley 2600B

Series 2600B
System SourceMeter® Instrument Reference Manual Section 5:
Introduction to TSP operation
2600BS-901-01 Rev. C / August 2016 5-19
TSP-Link
These functions and attributes allow you to set up and work with a system that is connected by a
TSP-Link
®
network.
The TSP-Link
®
is not available on the Models 2604B, 2614B, and 2634B. These commands are not
available on those models.
tsplink.group (on page 7-382)
tsplink.master (on page 7-383)
tsplink.node (on page 7-383)
tsplink.readbit() (on page 7-384)
tsplink.readport() (on page 7-384)
tsplink.reset() (on page 7-385)
tsplink.state (on page 7-386)
tsplink.trigger[N].assert() (on page 7-387)
tsplink.trigger[N].clear() (on page 7-388)
tsplink.trigger[N].EVENT_ID (on page 7-388)
tsplink.trigger[N].mode (on page 7-389)
tsplink.trigger[N].overrun (on page 7-391)
tsplink.trigger[N].pulsewidth (on page 7-392)
tsplink.trigger[N].release() (on page 7-392)
tsplink.trigger[N].reset() (on page 7-393)
tsplink.trigger[N].stimulus (on page 7-394)
tsplink.trigger[N].wait() (on page 7-396)
tsplink.writebit() (on page 7-396)
tsplink.writeport() (on page 7-397)
tsplink.writeprotect (on page 7-398)
TSP-Net
The TSP-Net module provides a simple socket-like programming interface to Test Script Processor
(TSP
®
) enabled instruments.
tspnet.clear() (on page 7-399)
tspnet.connect() (on page 7-400)
tspnet.disconnect() (on page 7-401)
tspnet.execute() (on page 7-402)
tspnet.idn() (on page 7-403)
tspnet.read() (on page 7-403)
tspnet.readavailable() (on page 7-404)
tspnet.reset() (on page 7-405)
tspnet.termination() (on page 7-405)
tspnet.timeout (on page 7-406)
tspnet.tsp.abort() (on page 7-407)
tspnet.tsp.abortonconnect (on page 7-407)
tspnet.tsp.rbtablecopy() (on page 7-408)
tspnet.tsp.runscript() (on page 7-409)
tspnet.write() (on page 7-410)