Keithley 2600B

Section
7: TSP command reference Series 2600B System SourceMeter® Instrument
Reference Manual
7-150 2600BS-901-01 Rev. C / August 2016
Also see
lan.trigger[N].assert() (on page 7-140)
lan.trigger[N].clear() (on page 7-141)
lan.trigger[N].connect() (on page 7-142)
lan.trigger[N].overrun (on page 7-146)
lan.trigger[N].wait() (on page 7-150)
lan.trigger[N].wait()
This function waits for an input trigger.
Type TSP-Link accessible
Affected by Where saved Default value
Function
Yes
Usage
triggered = lan.trigger[N].wait(timeout)
triggered
Trigger detection indication
N
The trigger packet over LAN to wait for (1 to 8)
timeout
Maximum amount of time in seconds to wait for the trigger event
Details
If one or more trigger events have been detected since the last time lan.trigger[N].wait() or
lan.trigger[N].clear() was called, this function returns immediately.
After waiting for a LAN trigger event with this function, the event detector is automatically reset and
rearmed regardless of the number of events detected.
Example
triggered = lan.trigger[5].wait(3)
Wait for a trigger with LAN packet 5 with a timeout of
3 seconds.
Also see
lan.trigger[N].assert() (on page 7-140)
lan.trigger[N].clear() (on page 7-141)
lan.trigger[N].overrun (on page 7-146)
lan.trigger[N].stimulus (on page 7-148)
localnode.autolinefreq
This attribute enables or disables automatic power line frequency detection at start-up.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW)
Yes
Not applicable
Nonvolatile memory
true (enabled)
Usage
flag = localnode.autolinefreq
localnode.autolinefreq = flag
flag
The auto line frequency detection setting:
true
or
false