Keithley 2600B

Section
7: TSP command reference Series 2600B System SourceMeter® Instrument
Reference Manual
7-132 2600BS-901-01 Rev. C / August 2016
lan.nagle
This attribute controls the state of the LAN Nagle algorithm.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes Power cycle Not saved 0 (lan.DISABLE)
Usage
state = lan.nagle
lan.nagle = state
state
1 or lan.ENABLE: Enable the LAN Nagle algorithm for TCP connections
0
or
lan.DISABLE
: Disable the Nagle algorithm for TCP connections
Details
This attribute enables or disables the use of the LAN Nagle algorithm on transmission control protocol
(TCP) connections.
Also see
lan.restoredefaults() (on page 7-132)
lan.reset()
This function resets the LAN interface.
Type TSP-Link accessible
Affected by Where saved Default value
Function Yes
Usage
lan.reset()
Details
This function resets the LAN interface. It performs the commands lan.restoredefaults() and
lan.applysettings().
Also see
lan.applysettings() (on page 7-122)
lan.restoredefaults() (on page 7-132)
lan.restoredefaults()
This function resets LAN settings to default values.
Type TSP-Link accessible
Affected by Where saved Default value
Function Yes
Usage
lan.restoredefaults()