7: TSP command reference Series 2600B System SourceMeter® Instrument
7-8 2600BS-901-01 Rev. C / August 2016
TSP commands
beeper.beep()
generates an audible tone.
Type TSP-Link accessible
Affected by Where saved Default value
Usage
beeper.beep(duration, frequency)
The amount of time to play the tone (0.001 to 100 s)
The frequency of the tone in Hertz (Hz)
Details
You can use the beeper of the Series 2600B to provide an audible signal at a specified frequency and
time duration. For example, you can use the beeper to signal the end of a lengthy sweep.
The beeper will not sound if it is disabled. It can be disabled or enabled with the beeper enable
command, or through the front panel.
Example
beeper.enable = beeper.ON
beeper.beep(2, 2400)
Enables the beeper and generates a
two-second, 2400 Hz tone.
Also see
beeper.enable (on page 7-9)
To Next Page
Loading...
