Keithley 2600B

Series 2600B
System SourceMeter® Instrument Reference Manual Section 7:
TSP command reference
2600BS-901-01 Rev. C / August 2016 7-157
Example
localnode.reset()
Resets the local node.
Also see
reset() (on page 7-173)
smuX.reset() (on page 7-232)
localnode.revision
This attribute stores the firmware revision level.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
revision = localnode.revision
revision
Firmware revision level
Details
This attribute indicates the revision number of the firmware that is presently running in the instrument.
When using this command from a remote node, localnode should be replaced with the node
reference. For example, node[5].revision.
Example
print(localnode.revision)
Outputs the present revision level.
Sample output:
3.0.0
Also see
localnode.description (on page 7-151)
localnode.model (on page 7-153)
localnode.serialno (on page 7-157)
localnode.serialno
This attribute stores the instrument's serial number.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
serialno = localnode.serialno
serialno
The serial number of the instrument