Keithley 2600B

Series 2600B
System SourceMeter® Instrument Reference Manual Section 7:
TSP command reference
2600BS-901-01 Rev. C / August 2016 7-217
Example
smua.measure.calibratev(1, 1e-4, 1e-5, 0.92,
0.903)
SMU channel A calibrates voltage
measurement using following values: 1 V
calibration range, 1e−4 for +zero
measurement reading, 1e−5 for +zero
DMM measurement reading, 0.92 for
+FS measurement read
ing, and 0.903 for
the +FS DMM measurement reading.
Also see
Adjustment (on page B-18)
smuX.cal.lock() (on page 7-201)
smuX.cal.restore() (on page 7-203)
smuX.cal.save() (on page 7-204)
smuX.cal.unlock() (on page 7-205)
smuX.source.calibrateY() (on page 7-235)
smuX.measure.count
This attribute sets the number of measurements performed when a measurement is requested.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW)
Yes
Instrument reset
SMU reset
Recall setup
Saved setup
1
Usage
count = smuX.measure.count
smuX.measure.count = count
count
Number of measurements
X
Source-measure unit (SMU) channel (for example,
smua.measure.count
applies
to SMU channel A)
Details
This attribute controls the number of measurements taken any time a measurement is requested.
When using a reading buffer with a measure command, this attribute also controls the number of
readings to be stored.
If smuX.measure.count is set to a value greater than 1, any measurement delay set by
smuX.measure.delay will only occur before the first measurement, while the
smuX.measure.interval controls the interval between successive measurements.
Example
smua.measure.count = 10
Sets the SMU channel A measure count to 10.
Also see
reset() (on page 7-173)
setup.recall() (on page 7-194)
smuX.measure.delay (on page 7-218)
smuX.measure.interval (on page 7-222)
smuX.measure.overlappedY() (on page 7-225)
smuX.measure.Y() (on page 7-229)
smuX.reset() (on page 7-232)