Keithley 2600B

Section
7: TSP command reference Series 2600B System SourceMeter® Instrument
Reference Manual
7-272 2600BS-901-01 Rev. C / August 2016
Also see
smuX.trigger.arm.set() (on page 7-250)
smuX.trigger.autoclear (on page 7-253)
smuX.trigger.endpulse.set() (on page 7-255)
smuX.trigger.initiate() (on page 7-259)
smuX.trigger.measure.set() (on page 7-261)
Triggering (on page 3-32)
smuX.trigger.source.stimulus
This attribute defines which event causes the source event detector to enter the detected state.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW)
Yes
SMU reset
Instrument reset
Recall setup
Not saved
0
Usage
eventID = smuX.trigger.source.stimulus
smuX.trigger.source.stimulus = eventID
eventID
Set to the event that triggers the end pulse source off action
X
Source-measure (SMU) channel (for example,
smua.trigger.source.stimulus
applies to SMU channel A)