Keithley 2600B

Series 2600B
System SourceMeter® Instrument Reference Manual Section 6:
Instrument programming
2600BS-901-01 Rev. C / August 2016 6-41
Figure 114: Create a new script with the name of an existing script
Rename a script
You can rename a script. You might want to rename a script if you need to name another script the
same name as the existing script. You could also rename an existing script to be the autoexec script.
To change the name of a script, use the command:
scriptVar.name = "renamedScript"
Where:
scriptVar
=
The global variable name
"renamedScript"
=
The new name of the user script that was referenced by the scriptVar
global variable
After changing the name, you need to save the original script to save the change to the name
attribute.
For example:
beepTwoSec.name = "beep2sec"
beepTwoSec.save()
Run the beep2sec script using the following command:
script.user.scripts.beep2sec()