Keithley 2600B - Reading Buffer

Series 2600B
System SourceMeter® Instrument Reference Manual Section 5:
Introduction to TSP operation
2600BS-901-01 Rev. C / August 2016 5-11
Reading buffer
Reading buffers capture measurements, ranges, instrument status, and output states of the
instrument.
bufferVar.appendmode (on page 7-17)
bufferVar.basetimestamp (on page 7-17)
bufferVar.cachemode (on page 7-18)
bufferVar.capacity (on page 7-19)
bufferVar.clear() (on page 7-20)
bufferVar.clearcache() (on page 7-20)
bufferVar.collectsourcevalues (on page 7-21)
bufferVar.collecttimestamps (on page 7-22)
bufferVar.fillcount (on page 7-23)
bufferVar.fillmode (on page 7-24)
bufferVar.measurefunctions (on page 7-25)
bufferVar.measureranges (on page 7-26)
bufferVar.n (on page 7-27)
bufferVar.readings (on page 7-28)
bufferVar.sourcefunctions (on page 7-29)
bufferVar.sourceoutputstates (on page 7-30)
bufferVar.sourceranges (on page 7-31)
bufferVar.sourcevalues (on page 7-32)
bufferVar.statuses (on page 7-33)
bufferVar.timestampresolution (on page 7-34)
bufferVar.timestamps (on page 7-35)
savebuffer() (on page 7-174)
smuX.buffer.getstats() (on page 7-196)
smuX.buffer.recalculatestats() (on page 7-197)
smuX.makebuffer() (on page 7-212)
smuX.nvbufferY (on page 7-231)
smuX.savebuffer() (on page 7-232)
Reset
Resets settings to their default settings.
digio.trigger[N].reset() (on page 7-60)
lan.reset() (on page 7-132)
localnode.reset() (on page 7-156)
reset() (on page 7-173)
smuX.reset() (on page 7-232)
timer.reset() (on page 7-365)
trigger.blender[N].reset() (on page 7-368)
trigger.timer[N].reset() (on page 7-378)
tsplink.trigger[N].reset() (on page 7-393)
RS-232
serial.baud (on page 7-187)
serial.databits (on page 7-188)
serial.flowcontrol (on page 7-189)
serial.parity (on page 7-189)
serial.read() (on page 7-190)
serial.write() (on page 7-191)