Keithley 2701 - Page 500

Multiple channels
Control commands 2-20
Controlling 2-17
Corrupt measurements 2-17
Operation 2-16
Anomalies 2-22
mX+b (math function) 5-8
Configuration 5-8
Rel 5-9
Setting units 5-13
N
Network Interface Card 10-9
Noise
Johnson noise equation E-5
Lowest settings 4-8
Source resistance E-5
vs. speed characteristics 4-8
NPLC setting 4-10
O
Offset-compensated ohms 3-24, 3-25, 3-26,
3-28, 3-30, 3-32
Enabling/disabling 3-24
Performing measurements 3-25
OPEN key 2-12, 2-19
Open thermocouple detector 3-43
OPEN: ALL 2-12, 2-19
OPEN: MULTI 2-19
Operation event status 11-13
Options 1-4
Output trigger 7-10, 8-5
P
Paired channels
see 4-wire functions
Password 10-4
Pead-to-peak buffer statistic 6-7
Percent (math function) 5-9
Configuration 5-9
Reference 5-13
Performance considerations 3-4
Plug-in switching modules 1-4, 1-8
Power module 1-15, 1-17
Power switch 1-11
Power-up 1-16
Sequence 1-18
Program message terminator (PMT) 10-26
Program messages 10-24
Programming syntax 10-21
Pseudocards 1-8, 2-6, 10-2
Q
Query commands 10-23
Questionable event status 11-17
Queues 11-2, 11-22
Clearing 11-4
Error queue 11-22
Output queue 11-22
Quick start 1-1
Exercises 1-29
R
Rack mount kits 1-6
Radio frequency interference E-6
Range 4-2
Auto ranging 4-3, 4-5
Commands 4-4
Keys 1-13
Manual ranging 4-3, 4-5
Measurement 4-2
Programming examples 4-5
Remote programming 4-4
Scanning 4-3
Range, Digits, Rate, Bandwidth, and Filter 4-1
Rate 4-8
Aperture 4-12
Bandwidth 4-12
Bandwidth conflict error 4-13
Commands 4-11
Programming examples 4-13
Remote programming 4-11
Scanning 4-10
Settings 4-9
RATE key 4-8
Ratio 5-15
Basic operation 5-16
Channel pairing 5-15
Commands 5-18
DCV 5-16
Delay 5-18
Enabling/disabling 5-18
Programming examples 5-19
Remote programming 5-18
Scanning 5-17
Ratio and channel average
delay 5-18
Reading count 7-10
Reading hold
Example 8-6
Readings
Maximum 4-2
Recall while storing 6-12
Recalling 6-6
Storing 6-5