Keithley 2701 - Page 501

Rear panel
Summary 1-14
Reciprocal (1/X) (math function) 5-10
Configuration 5-10
Reference junctions 3-34
External 3-35
Internal 3-35
Simulated 3-34
Registers
Bit descriptions 11-11
Clearing 11-4
Condition 11-17
Event 11-18
Event enable 11-18
Measurement event 11-14
Operation event 11-13
Questionable event 11-16
Service request enable 11-9
Standard event 11-11
Status byte and SRQ see Status byte and
service request (SRQ)
Status byte register 11-8
Status register sets 11-2, 11-10
Relative 5-2
Basic operation 5-2
commands 5-4
Pressing REL using rel commands 5-6
Programming examples 5-6
Remote programming 5-4
Scanning 5-3
Setting rel values 5-6
Relative, Math, Ratio, Channel Average,
and dB 5-1
Relay closure count 2-34
Reading relay closure count 2-35
Setting count update interval 2-35
Remote operations 10-1
Enhancements 10-2
Remote programing
Limits and digital output 9-12
Remote programming
Autozero and LSYNC 3-6
Basic measurements 3-51
Buffer 6-8
dB 5-20
Default and user setups 1-27
Digits 4-6
Display 1-20
Filter 4-20
Information 1-28
Math 5-12
Multiple channel control commands 2-20
Range 4-4
Rate and bandwidth 4-11
Ratio and channel average 5-18
Rel 5-4
Scanning 7-26
System channel control commands 2-12
Trigger and return readings 1-39
Triggering 8-14
Resistance measurements (Ω2 and Ω4) 3-20
4-wire common-side (CSID) ohms 3-32
Connections 3-20
Cable leakage 3-23
Front panel inputs 3-20
Model 7700 switching module 3-22
Shielding 3-22
Measurement methods 3-25
Constant-current 3-26
Effects of open test leads 3-30
Ratiometric 3-28
Offset-compensated ohms 3-24, 3-25,
3-26, 3-28, 3-30, 3-32
Resistors
Sorting 9-14
Response messages 10-27
Multiple 10-27
Sending 10-27
Terminator (RMT) 10-27
RJ-45 connector 10-10
RS-232
Connections 10-32
Connector 1-15
RS-232 interface
Baud rate 10-28
Connector 10-32
Operation 10-28
Selecting and configuring 10-30
Sending and receiving data 10-28
Signal handshaking (flow control) 10-29
Terminator 10-30
RTD equation F-8
S
Safety precautions
High energy circuits 3-3
Safety symbols and terms 1-3
SCAN 7-17
Operation overview 7-7
Scan
Advanced 7-14
Commands 7-27
Scanning 5-17, 7-1
Advanced 7-14
Advanced scan setup procedure 7-16
Allowed settings per channel 7-2
Auto scan 7-21