Keithley 2701 - Page 502

Basic scan 7-22
Buffer 7-22
Configuration 7-11
dB 5-20
Digital outputs 9-11
Digits 4-6
Examples 7-32
External trigger scan example 7-32
Filter 4-19
Fundamentals 7-2
Limits 9-4
Manual/external trigger scan 7-23
Math 5-11
Monitor scan 7-35
Monitor scan (analog trigger) 7-24
Operation 7-21
Process 7-4
Range 4-3
Rate and bandwidth 4-10
Ratio and channel average 5-17
Relative 5-3
Remote programming 7-26
Remote programming example 7-32
Reset 7-13
Resume scan after power-up 7-21
Sequential and non-sequential 7-3
Simple 1-36, 7-13
SCPI commands see FORMat commands, SCPI
reference tables, SCPI signal oriented
measurement commands, and SYSTem
commands
SCPI reference tables 15-1, 15-2
CALCulate commmand summary 15-3
DISPlay command summary 15-5
FORMat command summary 15-6
ROUTe command summary 15-6
SENSe command summary 15-8
STATus command summary 15-19
SYSTem command summary 10-6,
10-15, 10-31, 15-20
TRACe command summary 15-25
Trigger command summary 15-26
UNIT command summary 15-27
SCPI signal oriented measurement
commands 13-1
CONFigure:<function> [<rang>], [<res>],
[<clist>] 13-4
FETCh? 13-6
READ? 13-7
Settings
Default 1-22, 1-24
Setups 1-22
Commands 1-27
Remote programming 1-27
Restoring 1-23
Saving 7-21
Saving (power-on) 1-23
Saving (user) 1-22
Shielding 3-15, 3-22, E-8
Signal handshaking 10-29
Signal processing
Buffer D-5
Filter D-4
Limits D-5
Math D-5
OComp D-4
Output trigger pulse (VMC) D-4
Ratio and Ch Average D-6
Rel D-5
Signal processing sequence D-2
Slot numbering 2-6
Software 1-6
Source mode
Logic control 9-10
Specifications A-1
Speed
Setting measurement speed 4-10
vs. noise characteristics 4-8
Standard deviation buffer statistic 6-8
Standard event status 11-11
Status and error messages C-1
Status byte and service request (SRQ) 11-8
Commands 11-10
Status indicators
Ethernet 10-20
Status structure 11-1
Overview 11-2
STEP 7-7, 7-17
Operation overview 7-7
Switching modules 1-4, 1-8
Cables and connector kits 1-5
CARD commands 2-33
Closing and opening channels 1-32, 2-1
Connections 2-4, 2-5
Dual multiplexers 2-24
Identifying installed 1-8, 2-30
Installation 2-4
Model 7700 2-36
Queries 2-32
Viewing closed channels 2-30