09 Creating your own voices | 105
At the bottom of the screen:
• The first button allows you to switch between the 24 factory Drawbar presets.
• LOW DRIVE: AMOUNT/LP: Adjust the amount of the Overdrive and the frequency
of the low-pass filter that intervenes in the simulation of the rotating speaker of
the woofer of the Leslie cabinet.
• HIGH DRIVE: AMOUNT/LP: Adjust the amount of the Overdrive and the
frequency of the low-pass filter that intervenes in the simulation of the rotating
horns of the Leslie cabinet.
• KEY CLICK AMOUNT: Check the click level, from 0 to 127.
• REVERB SEND: Adjust the send to the reverb effect, from 0 to 127.
• ROTOR PRESET: Choose a factory setting of the rotary effect from the seven
available.
• GLOBAL LEVEL: Check the global voice volume level, from 0 to 127.
• The ROTOR PARAMETER button allows you to choose:
o HIGH ROTOR/LOW ROTOR: adjust the top and bottom; the rotor (rotating
speaker of the woofer) and the horns.
o The SOUND REFLECTION configuration includes three configurable
parameters with values from 0 and 127: DIRECT SOUND is the amount of
sound that propagates directly without reflection, REFLECTION
INTENSIVITY represents the intensity with which the sound wave reflects
with an angle of incidence when it encounters walls and obstacles, while
REFLECTION DELAY determines thedelay of the sound that returns after
bouncing against a wall or obstacle.
o IMPORT and EXPORT: allow the saving and loading of the 24 organ
sounds.
Expert advice
The tool can receive Drawbar volume control via Sysex:
F0 26 7B 48 05 Drawbar number (0-8), Vol (0-7f) F7
Drum Set Remapping
This is a function can be open by the three buttons of the DRUM SET REMAP area on the
screen within the DRUM SET function.
BASIC
To Next Page
Loading...
