ii | 01 Getting started
KEEP THIS INSTRUCTION IN A SAFE PLACE
PREVENTING RADIO/TV DISTURBANCE
This instrument operates on the radio frequency band. If it is not installed correctly and strictly in compliance
with the instructions provided it may disturb the reception of radio-television appliances. Although the
instrument you have purchased has been designed in compliance with applicable laws and in such a way as to
provide reasonable protection against such disturbances, there is no guarantee that these will not occur. To
check whether any disturbance you are experiencing is in fact produced by your instrument, turn it off to see if
the disturbance disappears. Turn the instrument on again to see if the disturbance reappears. Once you are
certain that your instrument is in fact causing the disturbance, take any of the following measures:
Adjust the antenna of the radio or TV receiver.
Place the instrument in a different position with respect to the radio or TV receiver.
Place the instrument further away from the receiver.
Connect the plug of the instrument to another socket so that the instrument and the receiver are connected to
two different circuits.
If necessary, call in a servicing technician.
POWER SUPPLY
When you connect the instrument to other appliances (amplifier, mixer, MIDI instruments etc.), ensure that all
these units are off first before making any connections.
Read the recommendations regarding Radio and TV disturbances.
INSTRUMENT CARE
Clean the surfaces of the instrument with a soft dry cloth. Never use gasoline, diluting agents, or solvents of
any kind.
OTHER PRECAUTIONS
If you wish to use your instrument in a foreign country and have doubts about the power supply, consult a
qualified technician before you leave. The instrument should never be subjected to strong shocks.
CURRENT ADAPTERS
When connecting this instrument to the mains socket, use only the KETRON current adapter supplied with the
instrument. The use of different current adapters may damage the power supply circuits of the instrument. It is
therefore of fundamental importance to use only an original adapter, requesting the correct model when
ordering a new adapter.
INFORMATION FOR USERS
“Implementation of Directive 2002/95/EC, 2002/96/EC and 2003/108/EC on reduced use of dangerous
substances in electrical and electronic appliances and waste disposal”.
The crossed bin symbol shown on the appliance means that at the end of its life the instrument must be
disposed of separately from other waste. At the end of its life the user should therefore take the instrument to
a separate waste centre for electronic and electrical products or return the same to the dealer when purchasing
a new and similar instrument, whichever is applicable. Disposing of the instrument correctly so that it may be
consequently recycled and disposed of in an environmentally compatible manner helps to prevent possible
negative effects to the environment and health and ensures that the components of the instrument are
recycled. Unauthorised disposal of the product by the user entails the application of administrative penalties.
To Next Page
Loading...
