Keysight N9927-90001 User’s Guide 549
Noise Figure Mode (Option 356 – CPU2 Only)
In this Chapter:
See Also
“Using Noise Figure” on page 550
“How to Define a Noise Figure Measurement” on page 554
— “Example: Typical Noise Figure Measurement Procedure”
on page 554
— “Overview of Softkey Menus” on page 555
— “How to Use DUT Measurement Setups” on page 562
— “Single / Continuous / Restart” on page 574
— “Points ” on page 574
— “Alignments” on page 575
— “Calculating Noise Figure Measurement Uncertainty” on
page 576
— “Using ENR Tables” on page 581
— “About ENR (*.enr), Preamplifier (*.amp), and DUT (*.dut)
Files” on page 582
— “Using Markers (Noise Figure)” on page 584
“Calibration Wizard” on page 585
“How to use Auto-Integration” on page 588
“Other Features Available” on page 594
“Troubleshooting” on page 595
“All about Markers” on page 598
“All about Limit Lines” on page 613
“All about Trace Math” on page 618
“All about Scale Settings” on page 620
Chapter 28, “Data Analysis Features.”
Chapter 31, “File Management.”
To Next Page
Loading...
Need help?
General
