Keysight Technologies N6900 Series User Manual

ABORt Subsystem
Abort commands cancel any triggered actions and returns the trigger system back to the Idle state.
Abort commands are also executed with the *RST command.
ABORt:ACQuire
ABORt:ELOG
ABORt:TRANsient
ABORt:ACQuire - Cancels any triggered measurements.It also resets the WTG-meas and MEAS-
active bits in the Operation Status registers.
ABORt:ELOG - Stops external data logging.It also resets the WTG-meas and MEAS-active bits in the
Operation Status registers.
ABORt:TRANsient - Cancels any triggered actions. It also resets the WTG-tran and TRAN-active bits in
the Operation Status registers. Note that this command does not turn off continuous triggers if
INITiate:CONTinuous:TRANsient ON has been programmed. In this case, the trigger system will
automatically re-initiate.
Parameter Typical Return
(none) (none)
Aborts the triggered measurement: ABOR:ACQ
Keysight N6900/N7900 Series Operating and Service Guide 210
6 SCPI Programming Reference

Keysight Technologies N6900 Series Specifications

General

Brand	Keysight Technologies
Model	N6900 Series
Category	Power Supply
Language	English