Command Quick Reference
Some [optional] commands have been included for clarity. All settings commands have a
corresponding query. See the Syntax Conventions for SCPI.
ABORT Subsystem
ABORt
:ACQuire Cancels any triggered measurements.
:ELOG Stops external data logging.
:TRANsient Cancels any triggered actions.
CALibrate Subsystem
CALibrate
:COUNt? Returns the number of times the unit has been calibrated.
:CURRent
[:LEVel] <value> Calibrates the current programming and measurement.
:MEASure <value> Calibrates the low range current measurement.
:SHARing Calibrates the Imon signal for paralleled units.
:TC Calibrates the temperature coefficient.
:DATA <value> Enters the calibration value read by the external meter.
:DATE <"date"> Enters the calibration date in nonvolatile memory.
:LEVel P1|P2|P3 Advances to the next level in the calibration.
:PASSword <value> Sets a numeric password to prevent unauthorized calibration.
:RESistance
:BOUT Calibrates the bottom out resistance.
:SAVE Saves the calibration constants in non-volatile memory.
:STATe 0|OFF|1|ON Enables or disables calibration mode.
:VOLTage
[:LEVel] <value> Calibrates the local voltage programming and measurement.
:CMRR Calibrates the voltage common mode rejection ratio.
DISPlay Subsystem
DISPlay
[:WINDow]
[:STATe] 0|OFF|1|ON Turns the front panel display on or off.
:VIEW METER_VI|METER_VP|METER_VIP Selects the parameters to display on the front panel.
:SAVer
[:STATe] 0|OFF|1|ON Turns the front panel screen saver on or off.
1 Quick Reference
26 Keysight N6900/N7900 Series Operating and Service Guide
To Next Page
Loading...
Need help?
General
