LIST Subsystem
List commands program an output sequence of multiple voltage or current settings. A comma-
delimited list of up to 512 steps may be programmed. Note that these commands only apply in the
presently active priority mode, either voltage priority or current priority.
[SOURce:]
LIST
:COUNt <value>|INFinity Sets the list repeat count.
:CURRent
[:LEVel] <value>{,<value>} Specifies the setting for each list step.
:POINts? Returns the number of list points.
:DWELl <value>{,<value>} Specifies the dwell time for each list step.
:POINts? Returns the number of list points.
:STEP ONCE|AUTO Specifies how the list responds to triggers.
:TERMinate
:LAST 0|OFF|1|ON Determines the output value when the list terminates.
:TOUTput
:BOSTep
[:DATA] <Bool>{,<Bool>} Generates a trigger out at the Beginning Of STep
:POINts? Returns the number of list points.
:EOSTep
[:DATA] <Bool>{,<Bool>} Generates a trigger out at the End Of STep
:POINts? Returns the number of list points.
:VOLTage
[:LEVel] <value>{,<value>} Specifies the setting for each list step.
:POINts? Returns the number of list points.
[SOURce:]LIST:COUNt <value>|MIN|MAX|INFinity
[SOURce:]LIST:COUNt? [MIN|MAX]
Sets the list repeat count. This sets the number of times that a list is executed before it completes. The
count range is 1 through 4096. Infinity runs the list continuously.
Parameter Typical Return
1 – 4096, *RST 1 <count>
Sets the list count to 10: LIST:COUN 10
Keysight N6900/N7900 Series Operating and Service Guide 240
6 SCPI Programming Reference
To Next Page
Loading...
Need help?
General
