COMBI
1.1
2.12.22.33.13.23.33.44.14.24.34.46.16.26.36.47.17.27.3
55
4.1–2: MIDI 1–2 (MIDI Filter 1–2)
4.1–2a: Damper CC#64, Portamento SW CC#65
Damper CC#64 [Off, On]
Specifies whether or not MIDI control change message #64
hold (damper pedal) messages will be transmitted and
received.
Portamento SW CC#65 [Off, On]
Specifies whether or not MIDI control change message #65
portamento on/off messages will be transmitted and
received.
■ 4.1–2b: UTILITY
☞ “Write Combination,” “Solo Selected Timbre” (1.1–1c)
4.2–1: MIDI 2–1 (MIDI Filter 2–1)
4.2–1a: JS+Y CC#01, JS–Y CC#02
JS+Y CC#01 [Off, On]
Specifies whether or not MIDI control change #1 (the +Y axis
of this instrument’s joystick, or specified as the “B” assign-
ment of a real-time control knob) will be transmitted or
received.
JS–Y CC#02 [Off, On]
Specifies whether or not MIDI control change #2 (the –Y axis
of this instrument’s joystick, or specified as the “B” assign-
ment of a real-time control knob) will be transmitted or
received.
■ 4.2–1b: UTILITY
☞ “Write Combination,” “Solo Selected Timbre” (1.1–1c)
4.2–2: MIDI 2–2 (MIDI Filter 2–2)
4.2–2a: JS X/Bend as AMS, Ribbon CC#16
JS X/Bend as AMS [Off, On]
Specifies whether or not MIDI pitch bend messages (the X
axis of this instrument’s joystick) will be received to control
the AMS (
☞p.221 “Alternate Modulation Source”) effect
assigned to JS X. (This is not a filter for MIDI pitch bend
message reception.)
Ribbon CC#16 [Off, On]
Specifies whether MIDI control change message #16
(selected as assignment B for real-time CONTROLS [1]–[4]
knobs, or assigned to the ribbon controller of a TRITON etc.)
will be transmitted or received.
■ 4.2–2b: UTILITY
☞ “Write Combination,” “Solo Selected Timbre” (1.1–1c)
Specifies whether the A and B mode effects of real-time
CONTROLS knobs [1], [2], [3], and [4] will be transmitted
and received. The A mode of each knob is fixed as a MIDI
control change message. For B mode, you can assign a MIDI
control change message in 2.2: Ed-Ctrl.
4.3–1: MIDI 3–1 (MIDI Filter 3–1)
4.3–2: MIDI 3–2 (MIDI Filter 3–2)
4.3–1a: real-time Control Knob 1, 2
Knob1 [Off, On]
Specifies whether MIDI control change message #74 (inter-
nal low pass filter cutoff frequency) for the A mode of knob
[1] and the MIDI control change message assigned to the B
mode of knob [1] will be transmitted and received.
COMBI 4.2: Ed–MIDI Filter2
4.1–2a
4.1–2b
4.2–1a
4.2–1b
COMBI 4.3: Ed–MIDI Filter3
4.2–2a
4.2–2b
4.3–1a
4.3–1b
To Next Page
