Korg Karma - Page 66

56
Knob2 [Off, On]
Specifies whether MIDI control change message #71 (inter-
nal low pass filter resonance or high pass filter cutoff fre-
quency) for the A mode of knob [2] and the MIDI control
change message assigned to the B mode of knob [2] will be
transmitted and received.
4.3–2a: Real-time Control Knob 3, 4
Knob3 [Off, On]
Specifies whether MIDI control change message #79 (inter-
nal filter EG intensity) for the A mode of knob [3] and the
MIDI control change message assigned to the B mode of
knob [3] will be transmitted and received.
Knob4 [Off, On]
Specifies whether MIDI control change message #72 (inter-
nal filter and amp EG release time) for the A mode of knob
[4] and the MIDI control change message assigned to the B
mode of knob [4] will be transmitted and received.
■ 4.3–1(2)b: UTILITY
☞ “Write Combination,” “Solo Selected Timbre” (1.1–1c)
4.4–1: MIDI 4–1 (MIDI Filter 4–1)
4.4–1a: SW1, SW2
SW1, SW2 [Off, On]
Specifies whether or not the effect of the [SW1] key and
[SW2] key will be transmitted and received.
[SW1] key and [SW2] key correspond to the control change
messages specified in 2.2: Ed-Ctrl.
This filter setting is valid for settings of SW1 Mod.(CC#80),
SW2 Mod.(CC#81), or Porta.SW(CC#65).
■ 4.4–1b: UTILITY
☞ “Write Combination,” “Solo Selected Timbre” (1.1–1c)
4.4–2: MIDI 4–2 (MIDI Filter 4–2)
4.4–2a: Foot Pedal/Switch, Other Control Change
FootPedal/Switch [Off, On]
Specifies whether or not the effect of the ASSIGNABLE
PEDAL/SWITCH will be transmitted and received. The
function is assigned in GLOBAL 6.1–1a.
This filter setting is valid when a MIDI control change is
assigned.
Other Ctrl Change [Off, On]
Specifies whether or not MIDI control change message not
covered in the preceding items MIDI Filter 1–4 will be trans-
mitted and received.
■ 4.4–2b: UTILITY
☞ “Write Combination,” “Solo Selected Timbre” (1.1–1c)
COMBI 4.4: Ed–MIDI Filter4
4.4–1a
4.4–1b
4.4–2a
4.4–2b