General information
Operating manual for INVEOR α | DOC01539818 - 0004 | 2017-01 | V2.0 EN 13
1.5 Qualified staff
In the context of this operating manual, qualified staff refers to electronics specialists who are
familiar with the installation, assembly, commissioning and operation of the drive controller and the
dangers involved, and whose specialist training and knowledge of relevant standards and
regulations provide them with the necessary abilities.
1.6 Proper use
If the device is installed in a machine, drive controllers may not be commissioned (i.e. intended
operation may not begin) until it has been determined that the machine complies with the
regulations of EC Directive 2006/42/EC (Machinery Directive); DIN EN 60204-1;
VDE 0113-1:2007-06 must be observed.
Commissioning (i.e. beginning intended operation) is only permitted if the EMC Directive
(2004/108/EC) is complied with.
The harmonised standards of DIN EN 50178; VDE 0160:1998-04 must be applied for this drive
controller along with DIN EN 60439-1; VDE 0660-500:2005-01.
This drive controller may not be operated in areas where there is a danger of explosion!
Repairs may only be performed by authorised repair bodies. Independent and unauthorised
intervention may result in death, injury or property damage.
The warranty provided by KOSTAL will be invalidated in such cases.
External mechanical loads such as stepping on the housing are not permitted!
Using drive controllers in equipment that is not fixed is considered as an exceptional
environmental condition and is only permitted if allowed by the standards and guidelines
applicable on site.
To Next Page
Loading...
