Kostal INVEOR Drive Controller - Transport & Storage; Long-Term Storage of Devices

General information
Operating manual for INVEOR α | DOC01539818 - 0004 | 2017-01 | V2.0 EN 17
IMPORTANT INFORMATION
Do not place flammable parts (e.g. cable ducts) directly or indirectly on the drive controller.
1.9.2 Transport & storage
DAMAGE TO PROPERTY POSSIBLE
Risk of damage to drive controller!
Risk of damage to drive controller from improper transport, storage, installation and assembly!
Transport the drive controller properly in its original packaging.
Always store the drive controller properly.
Only allow qualified staff to undertake installation and assembly.
1.9.3 Long-term storage of devices
IMPORTANT INFORMATION
If drive controllers have been in storage for more than 2 years, the following regeneration
process is required before installation / use under the nominal conditions:
 The drive controller must be connected to supply voltage (+/- 3 %) for 30 minutes without
the device being loaded. This applies to the motor connection as well as possible
consumers and connections to the application.
 Perform this process once before commissioning.
In all cases, observe the general requirements for storing drive controllers!