Kostal INVEOR Drive Controller - External Fault

Parameters
Operating manual for INVEOR α | DOC01539818 - 0004 | 2017-01 | V2.0 EN 91
4.233 VO-On delay Unit: s
Relationship
to parameter:
4.234
Parameter
manual:
P. xy
Transfer status:
2
min.:
0 Own value
(to be entered!)
max.: 10000
def.: 0
Specifies the length of the switch-on delay.
4.234 VO-Off delay Unit:
Relationship
to parameter:
4.233
Parameter
manual:
P. xy
Transfer status:
2
min.:
0 Own value
(to be entered!)
max.: 10000
def.: 0
Specifies the length of the switch-off delay.
5.3.10 External fault
5.010 / 5.011 External fault 1/2 Unit: integer
Relationship
to parameter:
4.110 / 4.111
4.230
Parameter
manual:
P. xy
Transfer status:
2
min.: 0 Own value
(to be entered!)
max.: 6
def.: 0
Selection of source via which an external fault can be reported.
0
1
2
5
6
=
=
=
=
=
Not assigned / INVEOR soft PLC
Digital input 1
Digital input 2
Virtual output (parameter 4.230) (V 03.70 and higher)
Analogue input 1 (must be selected in parameter 4.030)
(V 03.70 and higher)
If there is a high signal at the selected digital input, the
drive controller switches with fault no. 23 / 24 of external fault ½.
Parameters 4.110 to 4.113 Dix inverted can be used to invert the logic of the
digital input.