Commissioning
Operating manual for INVEOR α | DOC01539818 - 0004 | 2017-01 | V2.0 EN 53
4.1 Safety instructions for commissioning
DAMAGE TO PROPERTY POSSIBLE
If the information is not observed, the drive controller could be damaged and destroyed during
subsequent commissioning.
Commissioning may only be performed by qualified staff. Safety precautions and warnings must
always be observed.
CAUTION!
Risk of burns from hot surfaces!
Serious burns to the skin from hot surfaces!
Allow the drive controller's cooling elements to cool sufficiently.
DANGER!
Risk of death due to electrical shock!
Death or serious injury!
Be sure that the power supply provides the correct voltage and is designed for
the required current.
Use suitable circuit breakers with the prescribed nominal current between the
mains and drive controller.
Use suitable fuses with appropriate current values between the mains and drive
controller (see technical data).
The drive controller must be grounded with the motor according to relevant
regulations. Non-compliance may result in serious injury.
To Next Page
Loading...
