KTM 1190 RC8 EU 2008 - Installing the Locking Lever; Installing the Shift Drum Locating; Installing the Shift Shaft

30/ASSEMBLING THE ENGINE 120
200428-11
– Swing shift forks  to one side.
Info
Watch out for the shift rollers .
– Insert shift drum  into the bearing seat.
– Let the shift forks engage in the shift grooves.
200427-11
– Mount shift rails  with the pressure springs.
Info
Use a small amount of grease to fix the pressure springs in the shift rails.
– Check the transmission for smooth operation.
21.5Installing the middle suction pump
200426-11
– Mount external rotor  with the marking facing downward.
The marking is not visible after mounting.
– Mount pin  into the third hole of oil pump shaft  after shaft keyway .
– Slide internal rotor  over the pin.
200425-11
– Mount oil pump shaft  with internal rotor .
Marking  of the internal rotor is visible after mounting while that of the exter-
nal rotor is not.
– Oil the parts.
21.6Installing the crankshaft
200423-10
– Slide the crankshaft into the bearing seat.
Info
Position the connecting rod as shown in the photo.