KTM 1190 RC8 EU 2008 - 30;ENGINE - Work on Individual Parts; Work on the Right Section of the Engine Case

30/DISASSEMBLING THE ENGINE 91
200426-10
– Remove internal rotor  and pin  from the oil pump shaft .
– Remove external rotor .
19.41Removing the transmission shaft
200427-10
– Remove shift rails .
200428-10
– Swing shift forks  to one side.
Info
Make sure not to misplace shift rollers .
– Remove shift drum .
200429-10
– Remove shift forks .
Info
Make sure not to misplace the shift rollers.
200430-10
– Place the engine in an upright position.
– Remove lock ring  and the stop disk.
200431-10
– Pull both transmission shafts out of the bearing seats together.