14/LIGHT SYSTEM, INSTRUMENTS 59
– Pull out the orange programming key.
All black ignition keys are deactivated.
– Order a new black ignition key according to the key number on the KEYCODE-
CARD and activate it.
Activating ignition key:
– Press the emergency OFF switch into the position .
– Insert the orange programming key in the ignition lock.
– Switch on the ignition by turning the orange programming key to the posi-
tion .
EFI warning lamp (MIL) lights up, switches off, and then starts to flash.
The immobilizer indicator lamp lights up.
– Switch off the ignition by turning the orange programming key to the posi-
tion .
– Pull out the orange programming key.
– Insert the black ignition key in the ignition lock.
– Switch on the ignition by turning the black ignition key to the position .
EFI warning lamp (MIL) lights up, switches off, and then starts to flash.
The immobilizer indicator lamp lights up, switches off briefly, and
switches on again.
– Switch off the ignition by turning the black ignition key to the position .
– Remove the black ignition key.
– To activate further ignition keys, repeat the last 4 steps with the respective
ignition key.
– Insert the orange programming key in the ignition lock.
– Switch on the ignition by turning the orange programming key to the posi-
tion .
EFI warning lamp (MIL) lights up, switches off, and then starts to flash.
The immobilizer indicator lamp lights up, switches off briefly, and
flashes according to the number of functioning black ignition keys includ-
ing the orange programming key.
– Switch off the ignition by turning the orange programming key to the posi-
tion .
– Pull out the orange programming key.
All black ignition keys are activated included in this job sequence are acti-
vated.
17.2Setting ROAD or RACE mode
Condition
The ignition is on.
The motorcycle is standing.
400475-01
– Press the button and the button for 3 - 5 seconds.
– Press the button or the button briefly and repeatedly until the symbol is
on CHANGE MODE in the info display.
– Press the MODE button briefly.
The mode set is shown in the info display.
– Select ROAD mode or RACE mode with the button or the button .
– Press the MODE button briefly.
The settings are stored and the display changes to the SET‑UP menu.
– Press the button briefly and repeatedly until the symbol is on EXIT SETUP in
the info display.
– Press the MODE button briefly.
To Next Page
Loading...
