38/LUBRICATION SYSTEM 158
26.6Fitting oil filter
700291-01
– Insert the oil filter .
– Lubricate the O-ring of the oil filter cover. Fit the oil filter cover .
– Mount and tighten screws.
Guideline
Remaining engine screws M5 6 Nm (4.4 lbf ft)
26.7Filling up with engine oil
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
700301-01
– The oil must be topped up in two steps.
Engine oil 3.60 l (3.8 qt.) External tem-
perature: ≥ 0 °C
(≥ 32 °F)
Engine oil
(SAE 10W/50)
( p. 192)
External tem-
perature: < 0 °C
(< 32 °F)
Engine oil
(SAE 5W/40)
( p. 192)
– Remove the dipstick and top up the engine oil.
Engine oil (1st
quantity)
3.00 l (3.17 qt.) External tem-
perature: ≥ 0 °C
(≥ 32 °F)
Engine oil
(SAE 10W/50)
( p. 192)
External tem-
perature: < 0 °C
(< 32 °F)
Engine oil
(SAE 5W/40)
( p. 192)
– Replace the oil dipstick .
Danger
Danger of poisoning Exhaust gases are poisonous and can result in uncon-
sciousness and/or death.
– When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in a closed space.
– Start the engine and check that it is oil-tight.
– Remove the dipstick and pour in the remaining engine oil.
Engine oil (2nd
quantity)
0.60 l (0.63 qt.) External tem-
perature: ≥ 0 °C
(≥ 32 °F)
Engine oil
(SAE 10W/50)
( p. 192)
External tem-
perature: < 0 °C
(< 32 °F)
Engine oil
(SAE 5W/40)
( p. 192)
– Replace the oil dipstick .
Danger
Danger of poisoning Exhaust gases are poisonous and can result in uncon-
sciousness and/or death.
– When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in a closed space.
– Start the engine and check that it is oil-tight.
– Check the engine oil level. ( p. 155)
To Next Page
Loading...
