30/ASSEMBLING THE ENGINE 139
21.40Installing the oil filler tube
200313-10
– Mount the oil filler tube with the O-ring.
– Mount and tighten screws .
Guideline
Remaining engine screws M6 10 Nm (7.4 lbf ft)
21.41Installing the starter motor
200312-10
– Grease O-ring . Mount the starter motor.
Long-life grease ( p. 194)
200311-11
– Mount and tighten screw with the ground wire.
Guideline
Screw, starter motor M6 10 Nm (7.4 lbf ft)
21.42Checking the rear valve clearance
200328-10
– Remove special tool .
– Crank the engine several times.
– Set the engine to ignition top dead center of the rear cylinder. ( p. 78)
200482-10
– On all valves, check the valve clearance between the camshaft and cam lever.
Guideline
Valve clearance
Exhaust at: 20 °C (68 °F) 0.25… 0.30 mm (0.0098…
0.0118 in)
Intake at: 20 °C (68 °F) 0.10… 0.15 mm (0.0039…
0.0059 in)
Feeler gauge (59029041100) ( p. 196)
» If valve clearance does not meet specifications:
– Adjust the rear valve clearance. ( p. 140)
To Next Page
Loading...
