38/LUBRICATION SYSTEM 155
26.2Checking engine oil level
Info
The engine oil level must be checked at normal engine operating temperature.
– Stand the motorcycle upright on a horizontal surface.
700301-10
– Remove oil dipstick . Check the engine oil level in the measurement range.
Info
After switching off the engine, wait one minute before checking the level.
The engine oil level must be in the middle of the measurement range of the
oil dipstick.
» If the engine oil level is outside the specified range:
– Top up the engine oil. ( p. 159)
– Replace the oil dipstick.
26.3Changing engine oil and filter, cleaning oil screen
700349-01
– Drain the engine oil and clean the oil screens. ( p. 155)
– Fill up with engine oil. ( p. 158)
26.4Draining engine oil, cleaning oil screens
Warning
Danger of scalding Engine oil and gear oil get very hot when the motocycle is driven.
– Wear suitable protective clothing and gloves. If you scald yourself, hold the affected area under cold water immediately.
Warning
Environmental hazard Problem materials cause environmental damage.
– Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
Drain the engine oil only when the engine is warm.
To Next Page
Loading...
