38/LUBRICATION SYSTEM 157
700302-10
– Position the left exhaust cover .
– Mount and tighten screws .
Guideline
Remaining chassis screws M5 5 Nm (3.7 lbf ft)
26.5Removing oil filter
Warning
Danger of scalding Engine oil and gear oil get very hot when the motocycle is driven.
– Wear suitable protective clothing and gloves. If you scald yourself, hold the affected area under cold water immediately.
Warning
Environmental hazard Problem materials cause environmental damage.
– Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
– Place a suitable container under the engine.
700289-01
– Remove screws . Remove the oil filter cover with the O-ring.
700290-01
– Pull the oil filter element out of the oil filter case.
Circlip pliers reverse (51012011000) ( p. 195)
– Completely drain the engine oil.
– Clean the parts and the sealing area thoroughly.
To Next Page
Loading...
