KTM 1190 RC8 EU 2008 - Installing the Oil Filler Tube; Installing the Starter Motor; Checking the Rear Valve Clearance

30/ASSEMBLING THE ENGINE 137
200337-10
– Remove the cloth.
– Keep the timing chain tensioned. Push the cylinder down carefully and let the
dowel pins engage.
21.36Installing the front cylinder head
200336-11
– Mount the new cylinder head gasket.
– Mount the cylinder head. Mount and tighten the new cylinder head screws .
Guideline
Cylinder head screw M11x1.5 Tightening
sequence:
Using a criss-
cross pattern
Step 1
15 Nm
(11.1 lbf ft)
Step 2
30 Nm
(22.1 lbf ft)
Step 3
90°
Step 4
90°
lubricated with
engine oil
– Mount and tighten nuts  with the washers.
Guideline
Nut, cylinder head M6 10 Nm (7.4 lbf ft)
21.37Installing the front camshafts
200335-10
– Pull up the timing chain and insert intake camshaft .
Info
The intake camshaft is labeled with INFR.
– Place the timing chain over the rear sprocket of the intake camshaft.
Marking  is aligned.
– Position exhaust camshaft .
Info
The exhaust camshaft is labeled with EXFR.
– Place the timing chain over the rear sprocket and position the camshaft in the
bearing set.
Marking  is aligned.