30/ASSEMBLING THE ENGINE 134
21.32Installing the rear camshaft
200320-10
– Pull up the timing chain and insert intake camshaft .
Info
The intake camshaft is labeled with INRE.
– Place the timing chain over the rear sprocket of the intake camshaft.
Marking is aligned.
– Ensure that bleeder is seated correctly.
– Position exhaust camshaft .
Info
The exhaust camshaft is labeled with EXRE.
– Place the timing chain over the rear sprocket and position the camshaft in the
bearing set.
Marking is aligned.
200318-11
– Thoroughly clean all oil jets and blow them out with compressed air.
– Position the camshaft bearing bridge.
– Mount screws and tighten them from the outside to the inside.
Guideline
Screw, camshaft bearing support M6 10 Nm (7.4 lbf ft)
Screw, camshaft bearing support M8 Step 1
10 Nm (7.4 lbf ft)
Step 2
18 Nm
(13.3 lbf ft)
– Grease the O-rings and mount spark plug shaft insert .
21.33Installing the rear timing chain tensioner
200316-11
– After it has been positioned in the installation location, insert timing chain ten-
sioner with a new O-ring.
– Mount and tighten plug with the new seal ring .
Guideline
Plug, timing-chain tensioner M24x1.5 25 Nm
(18.4 lbf ft)
200317-10
– Remove screw and use the special tool to push the timing chain tensioner
toward the timing chain.
Release device for timing chain tensioner (61229021000) ( p. 200)
The timing chain tensioner unlocks.
– Mount and tighten screw .
Guideline
Screw, timing chain tensioner release M10x1 10 Nm (7.4 lbf ft)
To Next Page
Loading...
