KTM 1190 RC8 EU 2008 - Removing the Shift Shaft; Removing the Shift Drum Locating; Removing the Locking Lever

30/DISASSEMBLING THE ENGINE 87
19.31Removing the clutch facing
200405-10
– Loosen screws  of pressure cap  in a crisscross pattern and remove them
together with the spring retainers and the clutch springs.
– Take off pressure cap .
– Take off push rod .
200406-10
– Remove clutch discs , the support ring and the pretension ring.
19.32Removing the outer clutch hub
200408-10
– Insert special tool  into inner clutch hub  and outer clutch hub .
Clutch holder (61229003000) ( p. 198)
– Loosen nut  and remove it with the washer.
– Remove components  and  of the clutch pressure booster.
200409-10
– Remove outer clutch hub  with washer .
200410-10
– Remove needle bearing  and washer .