KTM 1190 RC8 EU 2008 - Installing the Force Pump

30/ASSEMBLING THE ENGINE 121
21.7Installing the left engine case
200422-11
– Mount dowels .
– Mount gasket .
– Check that dowel  is correctly seated.
400481-01
– Degrease the sealing area and coat thinly with sealant.
Loctite
®
5910
Info
Only coat the sealing area around the outside (see figure).
200421-11
– Attach the left engine case, using a plastic hammer if necessary to seat it properly.
Info
Do not tighten the engine case sections using the screws.
– Mount and tighten screws .
Guideline
Screw, engine housing M8 18 Nm (13.3 lbf ft)
– Mount and tighten screws .
Guideline
Screw, engine housing M6x60 10 Nm (7.4 lbf ft)
– Mount and tighten screws .
Guideline
Screw, engine housing M6x80 10 Nm (7.4 lbf ft)
– Mount and tighten screws .
Guideline
Screw, engine housing M6x90 10 Nm (7.4 lbf ft)
– Mount screw .