KTM 1190 RC8 EU 2008 - Installing the Torque Limiter and Idler; Installing the Ignition Pulse Generator; Installing the Generator Cover; Installing the Oil Drain Plug

30/ASSEMBLING THE ENGINE 129
21.22Installing the balancer shaft
200357-10
– Mount the rear washer and needle bearing.
– Mount balancer shaft .
Markings  and  are aligned.
– Mount washer .
21.23Installing the idler and timing chain on the left
200354-11
– Mount the rear washer.
– Position the timing chain according to the direction of travel.
200355-10
– Place timing chain  over the toothing of the idler.
Markings  and  are aligned.
– Slide on idler .
– Mount the needle bearing.
– Mount washer .