10/REAR WHEEL 42
700314-01
– Push the brake caliper support completely to the rear.
– Position the rear wheel, and position the brake caliper support between the rim and
the brake disc.
– Position the brake caliper on the brake disc.
– Position the rear wheel on the bearing surfaces in the swingarm.
700315-01
– Push the rear wheel forward as far as possible and place the chain on the rear
sprocket.
– Pull the rear wheel back and push in the wheel spindle.
700316-01
– Lay the chain adjuster on the tensioning screw.
– Position the chain adjuster and place it on the tensioning screw.
– Tighten nut .
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and
right chain adjusters must be in the same position relative to the reference
marks .
Nut, rear wheel spindle M25x1.5 90 Nm
(66.4 lbf ft)
Thread greased
– Operate the foot brake lever repeatedly until the brake linings lie on the brake disc
and there is a pressure point.
– Take the rear of the motorcycle off the work stand. ( p. 9)
– Check the chain tension. ( p. 45)
14.3Installing the rear wheel - when installing the engine
Warning
Danger of accidents Reduced braking due to oil or grease on the brake discs.
– Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents No braking effect when operating the rear brake.
– After installing the rear wheel, always operate the footbrake until the pressure point is reached.
To Next Page
Loading...
