KTM 1190 RC8 EU 2008 - Work on the Clutch Cover

30/ENGINE - WORK ON INDIVIDUAL PARTS 98
20.6Removing the left main bearing
200443-10
– Remove the screws and take off bearing shell bracket .
200444-10
– Mark joint  of the main bearing shells as shown in the figure.
200445-10
– Place the engine case section on special tool .
Press sleeve (61229045000) ( p. 201)
– Place special tool  with the smaller diameter on the bearing shells and press from
the inside to the outside.
Press drift/press sleeve (61229044000) ( p. 201)
20.7Installing the left main bearing
– Select the main bearing shells. ( p. 95)
200439-10
– Center the new main bearing shells  using special tool .
Press drift/press sleeve (61229044000) ( p. 201)
200446-10
– Place the inside of the engine case section on special tool .
Press sleeve (61229045000) ( p. 201)
– Align the face of the new bearing shell with the marking made when it was disas-
sembled.
– Press the bearing shells with the stepped side of special tool  through press
sleeve  from the outside to the inside, all the way to the stop.
Press drift/press sleeve (61229044000) ( p. 201)