30/DISASSEMBLING THE ENGINE 78
19.5Setting the engine to ignition top dead center of the rear cylinder
200308-10
– Remove screw of the generator cover.
200309-10
– Turn the crankshaft counterclockwise until markings of the rear camshafts are
flush with the edge of the cylinder head.
200310-10
– Remove screw .
Info
Look through the hole to check that the position notch of the crankshaft is
visible.
– Screw in special tool .
Engine blocking screw (61229015000) ( p. 199)
19.6Removing the starter motor
200311-10
– Remove screw with the ground wires. Take off the starter motor.
19.7Removing the oil filler tube
200313-10
– Remove screws .
– Remove the oil filler tube with the O-ring.
To Next Page
Loading...
