30/DISASSEMBLING THE ENGINE 83
200349-10
– Screw the special tool into the crankshaft.
Pressure piece (61229008000) ( p. 199)
– Mount special tool on the rotor, apply counterpressure, and pull off the rotor by
screwing in the screw.
Extractor (58429009000) ( p. 195)
– Remove the special tools.
200350-10
– Take free-wheel-gear from rotor .
19.22Removing the idler and timing chain on the left
200353-10
– Take off idler with washer .
200354-10
– Remove the timing chain, needle bearing and the washer lying behind it.
Info
If the timing chain is to be used again, note the direction of travel and the
cylinder on which it was used.
To Next Page
Loading...
