KTM 1190 RC8 EU 2008 - Removing the Heat Exchanger; Removing the Rear Timing Chain Tensioner; Removing the Rear Camshaft

30/DISASSEMBLING THE ENGINE 77
1930/DISASSEMBLING THEENGINE
19.1Clamping the engine into the engine work stand
200306-10
– Mount special tool  on engine work stand .
Engine work stand (61229001000) ( p. 198)
Engine holder (61229002000) ( p. 198)
– Mount the engine on special tool .
Info
Have an assistant help you or use a crane.
19.2Draining the engine oil
200480-10
– Remove oil drain plug  with the magnet, O-rings and oil screen.
– Completely drain the engine oil.
19.3Removing the front valve cover
200324-10
– Remove ignition coil .
– Remove screws . Take off the valve cover with the valve cover seal.
– Remove the spark plug using the special tool.
Spark plug wrench (75029172000) ( p. 202)
19.4Removing the rear valve cover
200307-10
– Remove ignition coil .
– Remove screws . Take off the valve cover with the valve cover seal.
– Remove the spark plug using the special tool.
Spark plug wrench (75029172000) ( p. 202)